Separate names with a comma.
Discussion in 'The Club House' started by bobski, May 6, 2013.
another weird vise (press). almost looks like a special tool for brakes or rotors or bearings?
boski - it looks like a polar bear in a snow storm!
Actually, now it looks like a I-beam clamp or hanger.
what does an i beam clamp do?
Looks like an old ball joint remover.
Or, with correct collars, a tool to make flange ends.
ball joint sounds right.
anyone got a pic of it in use?
I think it is a riveter. Used for hollow rivets. Kinda hard to see the end of the ram but I'm pretty sure that's it.
Does the end look like this---
so then the bottom is designed to take collets of differing sizes
Looks like a rivet setter or an alien ray gun disguised as some kind of screw thing.
Open the screw, slip over a V belt pulley, with the shaft passing through the slots at the left. Turn screw, screw pushes on the shaft, pushing the shaft out of pulley.
must be for a small pulley.
found it. i got 2 guys say its a ball joint tool . anyone got a pic of it in use?
Ball joint separator
Actually found it looking for something else!