vz58 Stock (non) removal

Discussion in 'Gunsmithing Forum' started by ProfBri, Jun 9, 2013.

  1. ProfBri

    ProfBri New Member

    38
    0
    0
    I can NOT get the stock bolt loose. My longest biggest screwdriver will fit in the slot if I force it inside the stock itself, and it locks in, but I just can not get it to turn in the slightest. It is just so frustrating :mad:. I applied some oil and let that sit for a few hours, nothing! :confused:

    Any clever ideas? I would really appreciate it.
     
  2. SSGN_Doc

    SSGN_Doc Well-Known Member

    6,920
    41
    48
    If you could fit it in a freezer, it will often cause screws to loosen,

    Kroil penetrating oil, or automatic transmission fluid can find their way into places over time.
     
    Last edited: Jun 9, 2013

  3. primer1

    primer1 Well-Known Member Supporter

    9,724
    118
    63
    Kroil and sunshine/ warmth to get it to creep better. Then cool it.

    Does your screwdriver have a square or round body? If its square, put a combination or crescent wrench on it for added torque while putting weight on the screwdriver. If its round try some visegrips.