Taurus Model 82 38 spl

Discussion in 'Revolver Handguns' started by gr8oldguy, Jan 26, 2013.

  1. gr8oldguy

    gr8oldguy New Member

    1,115
    0
    0
    I came across this old service revolver at Gander Mountain a few months ago. It was less than $200, so I decided to buy it. I was concerned because it looked so rough, but the first shot out of this old gun proved me wrong. It's solid as a rock and very accurate. I was going to refinish it, but I think I'll keep it just as it is. I would like to replace the grips, the grips are just nasty. I'd like to replace them with the same style two piece wooden grips that are on the gun now. Does anyone know where I can find them? thanks
     

    Attached Files:

    Last edited: Jan 26, 2013
  2. Sniper03

    Sniper03 Supporting Member Supporter

    7,713
    185
    63
    oldguy,

    You might check Gun Parts Inc. (Numrich Arms) They may have some new original issue grips for it. Also Cheaper than dirt has some decent looking rubber Hogue type grips. Also Midway USA has some wood grips for it I believe.
    Good Luck!

    03
     

  3. gr8oldguy

    gr8oldguy New Member

    1,115
    0
    0
    Thanks for the information. I'll be sure to check it out.
     
  4. HOSSFLY

    HOSSFLY New Member

    6,932
    0
    0
    Steel wool the piss outta them then slap on sum stain/sealer :)
     
  5. gr8oldguy

    gr8oldguy New Member

    1,115
    0
    0
    That will probably be the solution. Thanks