Speed Strip Kit installation bolt problem

Discussion in '.22 Rifle/Rimfire Discussion' started by Vincine, May 27, 2012.

  1. Vincine

    Vincine New Member

    3,495
    0
    0
    Okay, I installed a Speed Strip kit on my Ruger MkIII 22/45 over these past two days. It’s quite a challenge to get all the pieces adjacent to the hammer lined up so the pin can slide all the way back in. Everything works, until I put the mainspring back in. Then I can’t pull the bolt back for nothing. And I do know what the hammer positions are supposed to be for reassembly and where the dingleberry is supposed to hang so it goes into the slot in the mainspring housing.

    Anybody else have this problem with a Speed Strip Kit installation?