smith and wesson pistol problem

Discussion in 'General Handgun Discussion' started by cjturner09, Aug 17, 2011.

  1. cjturner09

    cjturner09 New Member

    1
    0
    0
    hi i have a smith and wesson 622 semi-auto target pistol i recently needed to take the barrel out of it and in order to do that i needed to take the safety, trigger assembly and hammer assembly out of the gun. I made sure i had all the peices and reasembled the gun the way that i thought it would fit . everything went together well except for the trigger assembly and now i cannot get the trigger to engage the hammer . Is there ayone out there who has any tips or tricks on putting this back together properly. any knowledge would be greatly appreciated
     
  2. bigtiller

    bigtiller New Member

    59
    0
    0
    Was the hammer back when you re-assembled it? I just looked at my manual and it does not go deep enough to get to the safety or trigger. The best I can do is a schematic for the 622 and it's clones.
     

    Attached Files: