Sights for pardner single shot

Discussion in 'Gunsmithing Forum' started by IsaahDuncan, Jul 3, 2013.

  1. IsaahDuncan

    IsaahDuncan New Member

    1
    0
    0
    I want to mount some kind of red dot on my pardner single shot 20gauge, but I'm clueless if it's possible or how to do it
     
  2. darthjkf

    darthjkf New Member

    200
    0
    0
    Duct tape?
     

  3. unclebear

    unclebear New Member

    1,154
    1
    0
    You might be able to just screw a mount on the barrel but I'm not really sure how thick the metal on the barrel is or you could make some type of sleeve or something that goes around the barrel for the mount but I'm not really sure I'd have to see it in person have measurments and I might be able to draw something up but I wouldn't be able to make it too much work and not enough time.
     
  4. Gatoragn

    Gatoragn Active Member

    3,937
    13
    38
    If it is not already drilled and tapped, a 'smith should be able to do so and allow you to attach a Weaver or Picatinny rail above the barrel's chamber.

    Would look something like this:
     

    Attached Files:

    Last edited: Jul 3, 2013
  5. Orphanedcowboy

    Orphanedcowboy New Member

    5
    0
    0
    Check and see if a rifle base will fit. If so, I have one you can have. It will possibly need to be drilled.