Shadow ops weaponry

Discussion in 'AR-15 Discussion' started by leam23, Jul 30, 2013.

  1. leam23

    leam23 New Member

    55
    0
    0
    I ordered and received two stripped lowers . The "holes" are not lining up for assembly of my trigger assembly . Anyone have any problems like this or with this specific lower ? I am quite certain my parts are good and assembles correctly ( or attempted to ). It is almost as if the lower itself was machined 1/8 inch low of what it should be for where the trigger pin should go
     
  2. monteros

    monteros New Member

    186
    0
    0
    Can you post some pictures?
     

  3. CGS

    CGS New Member

    445
    0
    0
    Post some pics and if you have another lower, measure off of that to see what/if it doesn't line up.
     
  4. leam23

    leam23 New Member

    55
    0
    0
    Thanks guys. Ill try to get some pics up soon. Its my first complete new build but i am not new to the platform as i do most of my own work on all my weapons including my ar's
     
  5. leam23

    leam23 New Member

    55
    0
    0
    I can't upload photos but .... Shadow ops has yet to respond to me and I did measurements on my factory rock river that is complete and the specs on shadow ops are off significantly . Need less to say I am done with them