Scope mounts for 40/65 Browning BPCR

Discussion in 'General Rifle Discussion' started by Tango1, May 9, 2007.

  1. Tango1

    Tango1 New Member

    11
    0
    0
    I have a Browning BPCR in 40/65 and have decided that I would like to install a scope for black powder cartridge load development.

    I note that both the barrel and the receiver are drilled and tapped from the factory but I have been unable to find any information on the type and model of mounts that can be used on this rifle. This rifle is relatively rare in Australia and none of the gunshops/smiths I have spoken with so far know much about it.

    Does anyone out there have any information regarding the type and model of mounts I could use to mount scopes with both 1" and/or 30mm tubes?