Saw the worst budda job!!!

Discussion in 'Curio & Relic Discussion' started by jpattersonnh, Dec 22, 2010.

  1. jpattersonnh

    jpattersonnh Active Member

    5,360
    5
    38
    I was picking up my sons barreled action from the Smith last night. He asked if I could look at an old rifle and tell him what it was and what it is worth.
    He explained that the gun was worked on by another smith years ago and this rifle was his clients fathers. It started life as an 1895 Chilean Mauser. My heart skipped when I looked at the side of the receiver. Then sank as soon as I looked at the work.
    OMG, I have never seen such lousy work. The bolt handle had been cut off too close to the bolt body and was pinned and welded badly, so the inletting on the stock (which was the original) was so deep only the ball was exposed. Next were the scope bases. Typical weaver, but the front holes were miss aligned and the rear had only 1 hole drilled and tapped. The rear sight was gone, but a newer front sight was installed on the chopped off barrel. The Safety was modified, it had been cut and what looked like and old spoon that was bent into a serpentine was welded on, again, all the welds had pockets and cracks showing.
    So this is what he has to do:
    1) Weld over the holes in the receiver for the scope and drill and tap them correctly.
    2) Take the bolt handle off, lengthen the shank and replace the handle. (he has the handle he removed from mine for material)
    3) replace the stock, the original butt plate was removed and a fugly pad installed, not fitted mind you.
    4) re-crown the barrel.
    5) replace the safety lever.
    6) re-blue the receiver.
    Personally, I would re-barrel it also as the barrel is so short, 18".

    Glad it is not my rifle!!!
    He has the receipt from the original work.

    Forgot to mention, she is still 7x57.
     
    Last edited: Dec 22, 2010
  2. Highpower

    Highpower New Member

    1,546
    0
    0
    Dang! That sounds like a project I'm currently working on. (Except it's a chain saw... ) Lots of TIG welding involved. :rolleyes:

    Sometimes you just have to know when to let them go, unless you are bored and want a challenge. It's painful I know, when you run across those poor abused former works of art. Having been the victim of that kind of "smith" myself in another life -- I can relate. Ruined an pristine Colt series 80 pistol of mine. I had to just let it drop and walk away, because if I would have gone back there it would not have ended well for either one of us. :mad:

    Sorry you had to bear witness to that carnage JP .... :cool: