savage axis trigger job

Discussion in 'General Rifle Discussion' started by purehavoc, Nov 22, 2011.

  1. purehavoc

    purehavoc New Member

    4,799
    2
    0
    before the much needed trigger job pull was just shy of 8# after the trigger rework , spring , polishing and the shims for the side slop it came out on the digital scale at 3.12#. as far as washers for shims the ones I bought were a little to thick and I put them on a sheet of sand paper and sanded them down just enough until it took out the slop and didnt bind , it took less than 5 minutes of sanding and checking to get it to a perfect fit .
    Now I need to get out there and get some rounds ran through this thing , its just been way to windy and rainy here to get it done but with a 4 day weekend things are starting to look good