Ruger SR45 issues?

Discussion in 'Ruger Handgun Forum' started by miamivice, Nov 4, 2013.

  1. miamivice

    miamivice New Member

    47
    0
    0
    I was wondering, now that the SR45 has been out for a bit, has Ruger been able to fix the limited issues some are reporting ? Light primer hits and slide not locking back after last round( mag issue)
     
  2. kjdeut

    kjdeut New Member

    101
    0
    0
    Haven't heard anything. Mine is experiencing the slide not stay open after the last shot, Also beginning to see where round fails to load all the way, seems like the foot of the round was catching when moving from the mag to the cylinder and ally goes in part way.

    Ken
     

  3. John_Deer

    John_Deer New Member

    6,624
    1
    0
    Sand the casting mark off the feed ramp. If that doesn't correct the issue you can get a heavier recoil spring. I wouldn't go more than 2 lb heavier. Wolff has the weight of the stock spring listed on their site.