Ruger mark III trigger

Discussion in 'Gunsmithing Forum' started by acostanzo, Mar 21, 2011.

  1. acostanzo

    acostanzo New Member

    1
    0
    0
    Is there a website that can give instruction on how to polish the sear / hammer / trigger on a Ruger Mark III. The Volquartzen (sp?) site is only fair on the internal disassembly and reassembly. I'd like to dress the internal components before I spend any money on this pistol. The barrel is great and I can shoot a 280 with it.... but to do better, especially on timed and rapid fire, I need a better trigger.... thanks
     
  2. danf_fl

    danf_fl Retired Supporter

    12,361
    34
    48
    Welcome to the forum.
    As general rule around here, we like to know a little back ground on you before we give any kind of trigger advice.

    There is an "Introductions" area where you will get greetings, salutations, etc...

    We are a cautious and safety minded bunch here, and triggers are normally left to those who have some experience.
     

  3. DrumJunkie

    DrumJunkie New Member

    4,823
    0
    0
    A Buckmark has a little better trigger than the Ruger out of the box. But I do really like the Ruger pistols. I'd get a gunsmith to do it unless I really knew what I was doing in there. It's easy to mess up if you're not too careful.
     
  4. ALS11

    ALS11 New Member

    63
    0
    0
    I installed a Volquartzen accurizing kit in my MK III. I found that the adjustable trigger was really great but I had some problems with the hammer and sear. I ended up putting back the original hammer and sear. It is real nice with that trigger though.
     
  5. stalkingbear

    stalkingbear Active Member

    4,078
    6
    38
    I would HIGHLY recommend you take it to a smith or buy the replacement aftermarket parts. It's too easy to screw up the angle or polish too much.