Ruger GP100 modification

Discussion in 'Gunsmithing Forum' started by Yonaledi, Dec 20, 2010.

  1. Yonaledi

    Yonaledi New Member

    2
    0
    0
    I have a GP100 4" stainless with a spurless hammer I want to change to double action spur hammer and reduce the trigger pull. Is this possible to do myself or do I need to send it to Ruger?
     
  2. stalkingbear

    stalkingbear Well-Known Member

    4,099
    40
    48
    If you are mechanically inclined you should be able to do it yourself. Finding a hammer might be a bit of a problem however. You can install a Wolff spring kit that will reduce the DA trigger pull by 30-40%. Would you still need to change the hammer over to a spur hammer if the felt trigger pull was reduced by 40%? Check Brownells, Midway, Ruger, and Gun parts corp for a hammer, and midway or Brownells for the spring kit.

    World's Largest Supplier of Firearm Accessories, Gun Parts and Gunsmithing Tools - BROWNELLS

    Shop Shooting Supplies | Reloading | Gunsmithing | Hunting gear — MidwayUSA

    Numrich Gun Parts Corporation