Ruger 10/22 takedown problem help?

Discussion in '.22 Rifle/Rimfire Discussion' started by hq357, Mar 30, 2013.

  1. hq357

    hq357 New Member

    714
    0
    0
    Okay so i took my ruger 10/22 TD Shooting it ran like a champ it disassembles just like regular 10/22 i was trying to get to the bolt to clean the insides but i could NOT get the pins out they are to thick i tried pushing them hammering and even lubed to get those pins out i tried with All my might and they will not come out i might take it to a gunsmith does anyone know what i can do??
     
  2. hmh

    hmh New Member

    962
    0
    0
    Had a similar problem, used a brass punch and a hammer. They are alot tighter than normal 10/22 and my bolt was tighter also. If all the clearance are tighter, more accurate?
     

  3. hq357

    hq357 New Member

    714
    0
    0
    I don't know what the problem is i do not want too mar or scratch the receiver i tried to use a punch but it just would not work is there something else i can do?
     
  4. hmh

    hmh New Member

    962
    0
    0
    Brass punch
     
  5. hq357

    hq357 New Member

    714
    0
    0
    Does brass scratch or gouge? Ive never done anything like this and im scared to smack my gun up
     
  6. hmh

    hmh New Member

    962
    0
    0
    Brass will not harm it. Have it positioned sturdy and give it a good wack not quite as hard as driving a nail. Do worry it is covered by the stock.
     

    Attached Files: