remington model 7600

Discussion in 'Gunsmithing Forum' started by m1shooter, Dec 5, 2012.

  1. m1shooter

    m1shooter New Member

    3
    0
    0
    what retains the large(outside) cam pin into the bolt/bolt carrier of a model 7600 pump rifle? thanks
    Sorry Duplicate
     
  2. Sniper03

    Sniper03 Supporting Member Supporter

    7,715
    197
    63
    M1

    There is a large pin on either side of the carrier that must be removed. Then remove the small pin in the rear that retains the firing pin. Then the bolt can be taken apart and pulled completely out. Do not loose the spacer ring or the firing pin spring. There is also a Gunsmith Video on YouTube somewhere with a guy doing exactly that on the 7600. I saw it a while back while I was doing some research regarding my Remington 740 Semi Auto.

    03
     

  3. Aderondacker

    Aderondacker New Member

    5
    0
    0
    If you are asking what keeps the pin from falling out it is the Ejector Port Cover, usually made out of plastic.

    Aderondacker