remington model 10

Discussion in 'General Shotgun Discussion' started by YoungSmith94, May 20, 2013.

  1. YoungSmith94

    YoungSmith94 New Member

    11
    0
    0
    I have a remington "pre-10". It gives a light strike on my reloads. I know my primers are sunk in just a shade but not enough for any of my other guns to notice. I found a good chunk of firing scraped off the end of the pin. So i was wondering can i buy a plain model 10 firing and put it in my pre-10? And is there any easier way to get the bolt out of the action. I have split my nail or cut myself everytime i pull it apart
     
  2. Dick471

    Dick471 New Member

    6
    0
    0
    Yes, any model 10 firing pin and spring will fit your gun. Google search for takedown of a Remington Model 10 to remove bolt, as I don't remember anymore.