Remington 870 Scope Mount

Discussion in 'General Shotgun Discussion' started by tCan, Aug 23, 2011.

  1. tCan

    tCan Active Member

    1,174
    0
    36
    Any of you guys have a recommendation for a Scope Mount? My 870 is not tapped so I'll need to use one that replaces the pins that keep the trigger group in place. Thanks.
     
  2. M14sRock

    M14sRock New Member

    5,549
    2
    0
    I have one of the old B-Square mounts and it worked fine when I used it.
     

  3. tCan

    tCan Active Member

    1,174
    0
    36
    I'm not familiar with setting up scopes, I always shot my dad's rifes. If I take the mount off and put it back on, will I need to sight it again?
     
  4. M14sRock

    M14sRock New Member

    5,549
    2
    0
    For a shotgun it should not be too far off. Keep the scope mounted on the mount, and mount it correctly when you mount it and a lot of your variables will be taken off the table.

    A better way to go would be to have the receiver drilled and tapped and install a Picatinny rail. Then use QD rings that are properly lapped and aligned, and you will be in better shape.