Refininshing Question

Discussion in 'General Handgun Discussion' started by EYEMAN, Dec 22, 2009.

  1. EYEMAN

    EYEMAN New Member

    3
    0
    0
    A new member with a question. I have an old Remington Model #6 childs falling block 22 that I am redoing. I have all the parts except for the pins that go through the receiver. Would someone know of something that could be used for these pins that is not necessarily gun related? Thanks for any help!:confused:
     
    Last edited: Dec 22, 2009
  2. masterPsmith

    masterPsmith New Member

    1,346
    2
    0
    They can be made very easy.........

    Jim..........
     

  3. EYEMAN

    EYEMAN New Member

    3
    0
    0
    Refinishing

    Yes I did order a couple of parts for this rifle from Numrich, but they are sold out of the pins that I need. Thanks though, for the info.
    Bob
     
    Last edited: Dec 22, 2009