Firearms Talk banner
1 - 20 of 23 Posts

·
Administrator
Joined
·
27,363 Posts
First, if what you HAVE is what is in the photo, you are not rebuilding a gun, but BUILDING a gun. The receiver (frame) is, by law, the gun. Everything else is parts. To buy a reciever, you will need to do the same things you would need to do to buy a complete pistol.

Here is a schematic that shows the parts. By the time you get them, pay a FFL to handle transferring the frame, I will bet you a beer you will have a LOT more $$$ in that than it would cost you to buy a COMPLETE working Raven.

http://www.gunpartscorp.com/Manufacturers/RavenArms-33451/MP25-37865.htm?results=All
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #7 ·
So really only parts i needed are
1 Recoil Spring
1 firing pin spring
1 Firring pin
1 retainer
1 safety switch
Grips or grip template
And magazine
And 2 other parts that have sloped my mind.
I have all the pins
 

·
Retired
Joined
·
14,025 Posts
I need everything but the slide
And I need grips or grip templates.
So really only parts i needed are
1 Recoil Spring
1 firing pin spring
1 Firring pin
1 retainer
1 safety switch
Grips or grip template
And magazine
And 2 other parts that have sloped my mind.
I have all the pins
You had me confused there. I though you needed the frame also. What you don't have for small parts could probably be picked up in a hardware store. The grips could be made or extensive internet search.
 

·
Retired
Joined
·
14,025 Posts
There is a strong possibility that the Jimenez parts could fit.

Check the history. IIRC, they are somewhat related in manufacturing equipment.
 

·
Registered
Joined
·
8,039 Posts
By the time you find all the parts and pay shipping you could probably buy another complete Raven and use that one for spare parts.
 
1 - 20 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top