post '64 winchester model 94 .30-.30. need a part

Discussion in 'General Rifle Discussion' started by shawnkfl, Nov 10, 2009.

  1. shawnkfl

    shawnkfl New Member

    1
    0
    0
    i'm doing a restoration on one. it was built in 1964, right at the down turn of the good models. anyway, this gun has not even had 10 shots through it. she's cleeeeaaan! other than years of dust internally that is. i've decided to strip it and clean everything. now i'm refinishing the stock. it had a nasty looking red rubber butt pad installed which is hard and dry now. i found a nice brass one yesterday that would require some fitting, but i liked it. now i cannot find it again :mad: anyone know where i can get one? the one i saw had a nice checkering on it.