Pierced Primers in Mini 14

Discussion in 'Mini-14 Forum' started by dusty_dragon, Sep 16, 2012.

  1. dusty_dragon

    dusty_dragon New Member

    19
    0
    0
    dear friends,
    need your help for a little moment.
    i own a ruger mini 14 ranch rifle 195 prefix, made in the middle of 1998.
    i'm the first owner and own it from 1999 on.
    it always performed very well, never had any issues.

    in the last time i encounter some probs with penetrated primers. all factory loads, PMC and Sellier&Bellot, no reloaded ammo.

    every 20 or so rds i have a cartridge on which the primer seems to be penetrated by the firing pin and after the round is fired there is more smoke than usual coming out of the bolt. still the gun performs perfect, no issues at all.

    the only thing i changed the last weeks is a stronger xtra power wolff recoil spring an 2 wilson combat 1911 buffers on front and rear of the spring guide rod/gas pipe.

    i can't see how that changes have an effect on the primers.

    is it a ammo related problem, a firing pin related problem, too strong hammer spring (factory spec)?

    best regards
    dusty
     
  2. tacticalfun

    tacticalfun Active Member

    2,243
    0
    36
    Do you have a point or burr on the tip of your pin?
     

  3. dusty_dragon

    dusty_dragon New Member

    19
    0
    0
    burr on lower half of the tip
     
  4. tacticalfun

    tacticalfun Active Member

    2,243
    0
    36
    Have a smithy file it for you.
     
  5. dusty_dragon

    dusty_dragon New Member

    19
    0
    0
    yes sir, think that's the problem, gonna see a smithy, thanks.

    do you think it got anything to do with the installed buffer(s) and xtra power spring, or is it just pure chance?

    just can't think about what the buffers and xtra recoil spring could have to do with the FP and it's burr.
     
  6. tacticalfun

    tacticalfun Active Member

    2,243
    0
    36
    I think your fp is just showing its age
     
  7. dusty_dragon

    dusty_dragon New Member

    19
    0
    0
    roger that, just another question, if you don't mind:

    I am concerned that the shock buff at the gas block / pipe will decrease the amount of travel of the slide handle, causing the bolt to unlock prematurely. There is an amount of play in the system, the slide assy has enough play and the bolt cycles not before a little bit of backwards movement of the slide assy

    do you think all is fine, or will the bolt unlock prematurely?
     
  8. tacticalfun

    tacticalfun Active Member

    2,243
    0
    36
    Id have to see it. Best bet is to let your smithy go over it
     
  9. dusty_dragon

    dusty_dragon New Member

    19
    0
    0
    okay, thanks.

    do you have any clue if the xtra power recoil spring (due to longer locking time) increases gas pressure on the breech face of the bolt and the FP?
     
  10. tacticalfun

    tacticalfun Active Member

    2,243
    0
    36
    Your pressure shouldnt increase.
     
  11. dusty_dragon

    dusty_dragon New Member

    19
    0
    0
    okay, so would you recommend to keep the 2 WC 1911 buffers (one on gas pipe and one on op rod end) and the wolff xtra power recoil spring in the rifle, cycling and funtion is 100%, no probs at all (after FP is filed round again) or does something speaks against that?