Well I finally got the Lee Classic Turret mounted and working. Not the prettiest setup but the bench was a $20 goodwill find that weights about 150lbs (which yes is sitting backwards so I could clamp the board down) the board is a 1x8x30 piece of maple with ran about $8 so total bench materials including hardware was just about $30 not too bad. I made 10 rounds of .45 acp but I have a little bulging where the bullet was seated. In the close up pic of two bullets the left is a factory speer round and the right one is the round I made. I used 4.2 grains of w231 and the overall length is 1.265. This is my first batch of home made ammo, so a quick question to all of you veterans out there does the loading info sound correct?