need help with winchester model 310

Discussion in '.22 Rifle/Rimfire Discussion' started by brownisdown, Apr 11, 2009.

  1. brownisdown

    brownisdown New Member

    I have a winchester model 310 and I want to remove the bolt to clean it. I have tried the usual tricks but none have worked. Is anyone familiar with the proceedure of removing the bolt on this model? Thanks in advance.
  2. Rex in OTZ

    Rex in OTZ Well-Known Member

    Have you taken it out of the stock yet? possibly that might give you some ideas on how its put together.

  3. North Patrol

    North Patrol New Member

    With the model 310 you need to turn the safety off, open the bolt, squeeze and hold the trigger fully then slide the bolt rearward. Make sure the bolt is completely out of the receiver before you let the trigger return.

    Mine is a little temperamental and I need to work the bolt a little while holding the trigger. It seems that some of them don't disengage the catch completely and you need to coax it out. I have also heard of a few that need to be dry fired (firing pin released) before they will come out.

    Just remember DON'T FORCE IT!!

    Good luck.