My refinish job

Discussion in 'Mini-14 Forum' started by monet61, Jan 9, 2011.

  1. monet61

    monet61 New Member

    108
    0
    0
    Hello;

    I wondered what others would think of my refinish job on my Mini14.
    I wanted something more subdued.
    Your opinions would be appreciated,
    Oh, by the way, the work was done by Acoating in Peoria,AZ.
     

    Attached Files:

  2. CA357

    CA357 New Member Supporter

    19,847
    3
    0

  3. DocWard

    DocWard New Member

    226
    1
    0
    Very cool. I like it a lot!
     
  4. masterPsmith

    masterPsmith New Member

    1,346
    2
    0
    Good looking finish. I like it.

    Jim.....
     
  5. Shihan

    Shihan Active Member Lifetime Supporter

    8,590
    2
    38
    Looks good. What does getting something like that done cost?
     
  6. mag318

    mag318 Member

    436
    0
    16
    That looks great and I'm sure it's better than the factory finish.
     
  7. rifleman55

    rifleman55 New Member

    299
    0
    0
    Looks fantastic. Great job, now just put a Choate handguard on it to finish it off. looks much better than the osha approved one.

    John K
     
  8. canebrake

    canebrake New Member

    21,833
    3
    0
    Nice.

    You hit the subdued target in the 10 ring.

    Great look!
     
  9. monet61

    monet61 New Member

    108
    0
    0
    my refinish

    Thank you for all the replies. I guess when it was all said and done, it cost me about $400.00. I know that's a lot, but he did some mags and if you could handle it, you would see how well done it is. I do intend to have my Glock done. I know tenifer don't need help, I just like the looks.
     
  10. M14sRock

    M14sRock New Member

    5,549
    2
    0
    Looks great! But $400? Ouch.
     
  11. Boyerracing343

    Boyerracing343 New Member Supporter

    1,461
    0
    0
    Looks very nice, little expensive but if you can afford it then why not? Once again looks great.
     
  12. KMO

    KMO New Member

    339
    0
    0
    It looks great. Is that finish applied over the Hogue synthetic stock?
     
  13. monet61

    monet61 New Member

    108
    0
    0
    Finish

    Yes it is refinished over the factory synthetic stock.
     
  14. KMO

    KMO New Member

    339
    0
    0
    That's a pretty cool finish if it will stick to all surfaces like that. Do they offer a warranty against flaking or chipping?
     
  15. monet61

    monet61 New Member

    108
    0
    0
    Refinish

    Yes, they do. I shoot it a lot, and I haven't seen any signs of failure of the finish.
    I would be very disappointed if it failed..