Modifying my 10/22 stock.

Discussion in '.22 Rifle/Rimfire Discussion' started by ta1588, Aug 19, 2009.

  1. ta1588

    ta1588 New Member

    344
    0
    0
    Hello, I recently saw a rifle similar to my own on a forum where someone had somehow attached a scope mount as a rail on the bottom of their stock in order to attach a forward grip, The result looked pretty amazing and I'm looking into doing so myself as the forward grip would assist in handling with the stock folded. I was just wondering what the best way to go about attaching the rail to the un-drilled stock would be? should i find a mount and get someone to drill the holes? anyone have any advice?
     
  2. easterner123

    easterner123 New Member

    348
    0
    0
    im not big on gunsmithing but welcome to the forum! go to the introduction section and let us know who you are.
     

  3. Dillinger

    Dillinger New Member

    23,972
    1
    0
    What kind of stock do you have? Wood? Composite?

    What you are talking about doing is kind of, well, kind of hokey to be honest, but it will serve the purpose...

    All you are needing to do is order a 1913 Picatinny Rail, in whatever length you want, then get a couple of screws and a couple of nuts.

    Take the stock off the gun. Measure, mark and drill a couple of holes into the stock that coincide with the holes in the rail.

    Turn the stock over and countersink the holes under the barrel so they don't have the nutss, or the screws, adding pressure to the barrel.

    Drop the nuts in the countersunk holes, thread the screws in from the bottom with the rail in place, trim screw length as needed.

    A little Locktite, or clear fingernail polish, and you are good to go.

    It's not like you are adding a scope rail to a 1,000 yard gun....

    JD
     
  4. Caliche

    Caliche New Member

    85
    0
    0
    Just go to rimfirecentral.com and read the stock mod thread.

    You will get more information than you can digest in a month.