Mini 14 Hogue Stock fitment issues

Discussion in 'Gunsmithing Forum' started by Jon360PD, Jul 1, 2009.

  1. Jon360PD

    Jon360PD New Member

    1
    0
    0
    Does anyone else have experience getting a Hogue Stock onto a Mini-14? It wasn't real co-operative, but it's on now. Unfortunately the front of the bolt assembly rubs on the stock a bit, slowing down it's return. Is it normal to need to trim the stock back a bit on the right side to clear the bolt assembly?
     
  2. M14sRock

    M14sRock Active Member

    5,549
    2
    38
    Yes, they usually need some trimming. Or, if you have a Dremel you can use the sanding drum and grind away until the fit is right. The Hogue stocks are very good once you get the fit squared away.