Marlin Model 100

Discussion in 'Gunsmithing Forum' started by gallen85, Mar 10, 2011.

  1. gallen85

    gallen85 New Member

    6
    0
    0
    I was wondering if anyone knew how to re assemble a bolt for a Marlin Model 100. I am having problems with the cocking knob assembly that slides into the bolt. There are two springs inside of it that I can not figure out the configuration. There is a pin you knock out to remove the assembly and after doing that you can not tell how the springs where in there. Any help is appreciated.
     
  2. stalkingbear

    stalkingbear Well-Known Member

    4,099
    40
    48