MAK-90 Stock Options

Discussion in 'AK & SKS Discussion' started by zstephens13, Jul 9, 2009.

  1. zstephens13

    zstephens13 New Member

    1
    0
    0
    I recently received a MAK-90 that my father-in-law has had locked up for 15 years or so.

    This is what the stock-end of my AK looks like[​IMG]:
    Sorry its small.

    What are my options for stocks on this gun? I want a side folding stock, not a wooden ironwood stock.

    Help me out guys!

    Thanks
     
  2. Carne Frio

    Carne Frio New Member

    54
    0
    0
    This is what I did on my Mak. Removed the stock, and upper and
    lower fore stocks. Put TAPCO on plastic folding set (comes with hand grip).
    Also replaced firecontrol group with the TAPCO G2 single hook parts.
    I dumped the shepard's hook and put in a retaining plate. It is now
    lighter and, for me, more functional. I added a USA muzzle device.
    It is 922 compliant. :D
     

  3. Seadog75

    Seadog75 New Member

    51
    0
    0
    I would hightly recomend an Ace AK Skeleton Stock from DSA. Top quality. A retaining plate to replace the shepords crook. Some lower handguard with heat shield from a KVAR. Just my liking but I recomend a Ultimack upper gass tube. It gives you some where to mount a red dot or forward scope and is rock solid and wont move on you. Realy good for under folders. Depending on the red dot you use it can also let you co witnees your iron sights. THATS A BIG ++++ As for trigers a Red Star adjustable will do the trick. Pre travel over travel. Nice clean crisp.. Those are my recomendations. Hope you like
     
  4. Carne Frio

    Carne Frio New Member

    54
    0
    0
    There yah go, Zstephen13. Two workable suggestions, one cheap and
    one quality. Now, get going and be sure to send us pictures when your
    done.:D
     
  5. crockett007

    crockett007 New Member

    209
    0
    0
    While the other guys are trying to be helpful, you need to not jump the gun. By this I mean you need to confirm that you have a stamped/milled square cut or angle cut receiver. If you have the angle cut, as I do, then the only option is Ironwood. The options listed by our other members WILL NOT FIT YOUR WEAPON! Remove the butthole stock and check your receiver! If it is square cut, you are in business!

    regards