Firearms Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter · #1 ·
I did one in Delrin polymer already(other thread further down). That was in anticipation for doing this one. It worked fantastically! Started with a 22mm round bar of 6AL4V Ti. Drilled & tapped
5/16-24. Cut on my bandsaw to 1.5” starting length. Then contoured similar to the Badger style. I post more pictures after I sand blast & Cerakote. I have 14 small parts I need to Cerakote including this & the Ti Bolt Handle I have for my build.

6AL4V Ti. 22mm round bar.




 
1 - 3 of 3 Posts
Top