M44 Scope Mount Question

Discussion in 'Curio & Relic Discussion' started by fapprez, Jul 3, 2008.

  1. fapprez

    fapprez New Member

    496
    0
    0
    So, I'm sure this is a lame question and I'm wasting your time, but seeing as how you are still reading, I'm guessing you have time to waste.

    I was bored and was surfing Ebay ( just lost half of the readers) and stumbled acrossed a listing for a scope mount made to bolt on in place of the existing rear sights. They claim no gunsmithing needed.

    Do you think it could work? Would it be sturdy enough to not wobble after one round? It's only $16 with shipping but I'd rather spend it on surplus ammo than a cruddy scope mount.

    Here is the link:
    http://cgi.ebay.com/NO-GUNSMITHING-...ryZ52510QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
     
  2. c3shooter

    c3shooter Administrator Staff Member

    21,515
    819
    113

  3. fapprez

    fapprez New Member

    496
    0
    0
    Cool Article, Thanks!
     
  4. Righteous

    Righteous New Member

    573
    0
    0
    even with the scope the M44 is still not going to be a tack driver and is not ment to be.
     
  5. dragunovsks

    dragunovsks New Member

    2,310
    0
    0
    I think I like the M44 with the original military stock better. I would get a synthetic stock for mine only if the original was in bad shape.
     
  6. karlsgunbunker

    karlsgunbunker New Member

    47
    0
    0
    This is the best one I've found for under $80.

    MilSurpStuff.com Products

    Very firm mount much better than the B-Square or NC-Star scout mounts.

    I have 2 and I'm very happy with them.
    I don't use the rails, my Mosin's are NOT Tacticool.
     
  7. fapprez

    fapprez New Member

    496
    0
    0
    That's a whole lot nicer than the one I was looking at. The one I had found looked like cheap junk and I had read that the screws were junk and you needed to replace with steel screws and still add loc-tite. All this and you may still have to rezero before using.