M&P Magazine Disconnect - GONE!

Discussion in 'Gunsmithing Forum' started by dnthmn2004, Apr 17, 2011.

  1. dnthmn2004

    dnthmn2004 New Member

    3,287
    0
    0
    There was a thread around a while ago about removing the magazine disconnect from a handgun, specifically an M&P. Well I finally got around to it tonight. It was super easy, as expected. The hardest part was finding a suitable replacement spring to keep the sear disconnect in place. I ended up sacrificing an old Zebra pen to get the best, free, quality spring I could.

    Initial dry firing results - the trigger is noticeably smoother, but not a lot. I am anxious to take it to the range soon.

    I would recommend this simple fix to you guys who have an M&P or other handgun with a mag disconnect.

    Note: The old spring that was providing the pressure on the mag disconnect did the old "I'm going to disappear in less than a blink of an eye and make a tiny sound on the other side of the room when I hit something, only I will never be found again until I get impaled on the bottom of your foot" trick. W/E, I don't need it anymore.
     

    Attached Files:

  2. dog2000tj

    dog2000tj New Member

    8,176
    2
    0
    Didn't we learn anything from our AR build and flying springs? :rolleyes:
     

  3. dnthmn2004

    dnthmn2004 New Member

    3,287
    0
    0
    Learn? Yes. Put that lesson to work? No.

    I have one of those "thick skulls".
     
  4. stalkingbear

    stalkingbear Well-Known Member

    4,099
    40
    48
    Excellent! Thanks for sharing that.