laser engraving

Discussion in 'AR-15 Discussion' started by yoteseeker, Sep 7, 2012.

  1. yoteseeker

    yoteseeker New Member

    14
    0
    0
    Cost to have an ar15 lower done?Thanks in advance!:rolleyes:
     
  2. mountainman13

    mountainman13 New Member

    11,488
    0
    0
    Welcome to FTF. Not sure what the :rolleyes: is about but, it depends on what you want. It's usually a setup fee and flat rate per square inch usually somewhere in the $35/" range. I have a guy that does it if you want contact info.