Kel-Tec P3at take down?

Discussion in 'Gunsmithing Forum' started by DiabloMan, Mar 12, 2013.

  1. DiabloMan

    DiabloMan New Member

    57
    0
    0
    I have a Kel Tec p3at, how do you get that take down pin out? Crow bar? This little 380 shoots great. It is a good pocket gun for CCW. I have pryed as much as I dare, WTH! Any suggestions other than the crow bar? Thanks The Blackhawk Kid:)
     
  2. robertusa123

    robertusa123 New Member

    348
    0
    0
    without pulling back the slide. use the rim of the bullet to pry out the pin pull the slide back then fowared off the frame. you can down load the instruction from the keltech sight. if you bought the gun new look under the foam in the box it came in.
    also theirs a spring that holds the pin in place dont be supprised when it goes pop when your prying on it
    when all else fails u-tube
    [ame]http://www.youtube.com/watch?v=GJwEICE1f9w[/ame]
     
    Last edited: Mar 12, 2013