Kahr cm 9 mod

Discussion in 'General Handgun Discussion' started by glockcj, Mar 20, 2013.

  1. glockcj

    glockcj New Member

    36
    0
    0
    I have put a total of 500rnds though it and cleaned it. I noticed shavings on the ploy rail and looked at the top slide that is SS. I was wondering if I should file the SS slide it has a sharp edge. Do you think it is a good idea or should I wait to see if poly stops wearing. Advise
     
  2. hardluk1

    hardluk1 Active Member

    2,879
    4
    38
    Clean it up? Yes but should be done wearing by now . The plastic rails"assembly" rails that is will stop wearing and if you wish to make them look nice take some sandpaper after them or just scrap any plastic edges flat with a pocket knife. I do with any pistol soften any sharp edges and did so with my kahrs but not really needed. Go over talk kahrtalk and intro your self and do some searchs before asking questions. Most results have been covered thru the years.