JC Higgins model 88 ejector spring replacement

Discussion in 'Gunsmithing Forum' started by Bob Thib, Jun 30, 2020 at 10:32 PM.

  1. Bob Thib

    Bob Thib New Member

    1
    0
    1
    Anyone got any idea on how to remove the ejector on this old 22 revolver? I believe it was manufactured by High Point or High Standard in the 60s for Sears.
    The spring is broken. Hints on where to source one, or a suitable replacement would also be appreciated.
     
  2. c3shooter

    c3shooter Administrator Staff Member Admin Moderator Lifetime Supporter

    25,145
    14,016
    113
    Hi Bob! Welcome to the forum (saw that was yer first post)
    Your revolver was made by High Standard for Sears. Here is a schematic that is probably pretty close. 2 springs- one in stock for $4 plus shipping, the other (of course) out of stock.

    https://www.gunpartscorp.com/gun-manufacturer/high-standard/revolvers-hs/double-nine-w-102

    Big disclaimer- I AM NOT A GUNSMITH. Have not even held one of these in years- and I would defer to any good pistol smith. Most will have assorted cut-to-size springs in their parts stock. Think that one has a tiny cross pin on the rear most bit of the ejector.

    Maybe better quality picture. Pin is 7112
    https://histandard.info/manuals/hprevolvers/0089D150R.pdf
     
    OLD Ron likes this.