I need help replacing a hammer

Discussion in 'General Shotgun Discussion' started by jdwatson10, Jun 24, 2010.

  1. jdwatson10

    jdwatson10 New Member

    1
    0
    0
    Hi, im trying to replace a hammer on my 20 gauge im haveing trouble with the roll pins but once i get them out what do i do then? Thanks for any and all help. Jordan
     
  2. dunerunner

    dunerunner New Member

    8,411
    3
    0
    Jordan, Welcome to the FTF!!

    Go over to the Introductions thread and tell us a little about yourself and how you found this forum.

    Who makes the shotty? Is it an exposed hammer or internal? Pics?
     

  3. spittinfire

    spittinfire New Member Supporter

    9,663
    4
    0
    A little info on the weapon would go a long way here. Pics wouldn't hurt either.

    Welcome to the forum!
     
  4. Hawg

    Hawg Active Member

    1,505
    1
    38
    Roll pins in a shotgun? I don't think so. Should be solid pins. Once the stock is removed you should be able to see what you're doing.
     
  5. Gojubrian

    Gojubrian New Member

    6,262
    5
    0
    Ok, you're going to need some bubble gum, duct tape, a left handed phillips screwdriver and some grid squares.

    Go get them and report back, we'll go from there.
     
  6. stalkingbear

    stalkingbear Well-Known Member

    4,094
    28
    48
    It's going to be impossible to help the poster without more info &/or pics so we can identify the shotgun and how to fix it. The methods for replacing hammers on shotguns vary widely and how you change 1 type is useless to the other kinds.
     
  7. suprdave

    suprdave New Member

    3,409
    1
    0
    Brian, I thought you were an "expert". You forgot bailing wire...:rolleyes: