Firearms Talk banner
1 - 8 of 8 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
As a long-time wheel gun guy who is looking to purchase his first auto loader, I would love to hear what you guys think about the Hi-Power. I have been lusting over several m1911A products that are on the market, but what about the Master's other creation...especially in a .40 SW?
 

·
Administrator
Joined
·
27,442 Posts
Cannot speak to the .40, but have a Hi-Power in 9mm. Other than a set of Hogue grips, and an ambi-safety, is pretty much stock. If a S&W Mdl 10 fits your hand, it will fit. Digests factory or handload ammo without a hiccup, more accurate than I am. Field strips in 20 seconds. John Browning looked at the 1911, and said "Hmm- ya know, I think I could do better.....".:D Of course, IS a single action, has a magazine safety, which some folks don't like- but IMNSHO, you could do a lot worse. 14 rds of 9mm in a fairly compact package.
 

·
RIP - In Memoriam
Joined
·
11,377 Posts
P-35, High Power, GP. Fine weapons. Feel very nice in the hand. Perhaps a "dated" design ( Oh, I will get flamed for that one). Magazine disconnector. Hammer bite with standard spur hammer (and big hands). Commonly referred to (by 1911 types as the Half Power in 9mm or 3/4 power in .40)

For the $'s, I think I would get a CZ-75 or clone and a case or two of ammo.
 

·
Premium Member
Joined
·
19,840 Posts
You will not go wrong with a Hi Power. There are certainly more modern 9mm platforms out there, but the Hi Power is a true classic. It was designed for the caliber.
 

·
Registered
Joined
·
5,554 Posts
Legendary pistol. Remove the magazine disconnector and it will feel like you just had a nice trigger job done.

If you get an older model, track down an extended safety for it. The tiny little dimple safety they came with is worthless. One of the "made in Belgium, assembled in Portugal" versions will have the extended safety.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top