Firearms Talk banner
1 - 11 of 11 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
This one isn't real fancy but it came out looking great. The script lettering is inlaid with 24k gold wire. After the gold was in and polished, I re-blued the barrel and slide. It's a Browning Buckmark so the front sight and rear base are aluminum and couldn't be blued but the color matches a lot better in real life. My camera pulled a lot of "blue" out of the barrel so it looks like the sight is a completely different color. Please feel free to comment.

David
 

Attachments

·
Registered
Joined
·
1 Posts
It looks really great. I have a SA1911 that I was thinking about inlaying. Any tips or suggestion? I have never done it before like I said just thinking about it.
 

·
Registered
Joined
·
49 Posts
Discussion Starter · #3 ·
Thank you very much.

How much engraving experience do you have? Inlaying straight lines that are the same width isn't all that tough. It is, however, pretty time consuming. Tight curves and widths that vary are a little more difficult but with a little practice can come out beautifully.

Let me know what you are wanting to do and I'll try and help. Plain border lines, block lettering, script, etc.

David
 

·
Registered
Joined
·
9 Posts
Nice clean lettering . This isn't all that easy when the lettering has to be cut deep enough to accomidate undercutting each letter for gold inlay & keeping lines smooth. Big time congrats david on a job well done.
 

·
Registered
Joined
·
9 Posts
You're most welcome Mr. David. It is easy for me to spot good work as I now have 50 years experience working in the firearms engraving trade. After you are able to put as many years in the trade as I have , you will no doubt be able to do better than I do now. The art of firearm engraving is on the up swing --- there is a demand for higher quality work coming from clients & younger guys like you will lead the way holding the torch high. Best regards ............

Mr. Canebreak, again I would like to thank you for your help. When it comes to computers, I'm a first class dummy.
 

·
Registered
Joined
·
64 Posts
Well Done !!

I don't know how much experience you have doing this work. I was a smith for BrowninG for almost 40 years and seen some of the best. Sooo if you are new to this I think it looks pretty good. Best of luck to you and it is " WELL DONE " !!!
 

·
Registered
Joined
·
15 Posts
That's beautifully done, I've yet to try my hand at doing some engraving on anything other than wood. Anybody have any pointers on a good resource for good quality engraving tools that are preferably NOT made in china?
 

·
Registered
Joined
·
15 Posts
Thank you for the info. I see myself dedicating some study time to learning how to do both engraving and inlay work.
 
1 - 11 of 11 Posts
Top