front sight gas block install

Discussion in 'AR-15 Discussion' started by purehavoc, Apr 1, 2014.

  1. purehavoc

    purehavoc New Member

    4,799
    2
    0
    I have been going to do this for a long time and have kept putting it off until I buy a mill. I decided to convert my drill press into a make shift mill and installed a table to do other thing like 80% lowers for myself . Tonight I put on a undrilled fsp gas block on a undrilled barrel for S&G . Honestly it turned out straighter than most of the pre assembled barrels I have bought in the past . Doesnt take long , it just takes the right tools to do it and a little bit of time


    [​IMG]


    [​IMG]


    [​IMG]


    [​IMG]



    [​IMG]
     
    Last edited: Apr 1, 2014
  2. JonM

    JonM Moderator

    20,110
    12
    38
    I give you props for having ginormous juevos for diy that without a jig!!
     

  3. purehavoc

    purehavoc New Member

    4,799
    2
    0
    Also preformed a little surgery on a 14.5" barrel with a pinned flash hider, not as clean as I would have liked but it works, Next time I will go with a little smaller hole and pin

    [​IMG]


    [​IMG]