Front Buffer Success? Heat Resistant?

Discussion in 'Mini-14 Forum' started by KMO, Apr 21, 2010.

  1. KMO

    KMO New Member

    339
    0
    0
    Several here have already discovered that 1911 pistol recoil buffers fit nicely in the Mini-14. Of course, this is at the guide rod (rear) end of the assembly. Some have experimented with a second buffer at the front end too, placed around the gas pipe. I saw MasterPsmith's photo of one that he used at that end, and it resembled the "cooked" experiments I've tried. Does anyone know of a heat-resistant material that also has a cushioning effect? As I stated on another thread, I grew weary of the molten "goo" I was creating, so I haven't tried anything recently. Ideas?
     
  2. Deadman1

    Deadman1 New Member

    136
    0
    0
    You probably should check into a bi-layer or even a three layer EPDM material. Like what high performance automotive hoses are made from. It won't be subject to melting and probably has some of the buffering qualities you're looking for. ;) Any gearhead will know what it is.
     
    Last edited: Apr 21, 2010

  3. KMO

    KMO New Member

    339
    0
    0
    I actually have tried some high temp automotive gasket material, but it didn't have much real cushion to it. After awhile, it tended to get harder. But, Deadman1, you might have something there with your "three-layer EPDM material" idea. Problem is, I'm not sure the employees at my local NAPA can even spell EPDM material...:cool:
     
  4. m72law

    m72law New Member

    1,316
    0
    0
    if you can find some 1/4'' viton material...it works great for buffer making....just have a sharp razor knife handy and you can use spent cases (chamfer until really sharp) for the recoil spring/s hole..i have shot over 1500rds out of my M-14 polytech rifle after installing a homegrown buffer using viton gasket...and the buffer still looks new;)