Free float 10/22

Discussion in 'Gunsmithing Forum' started by Fisherking, May 11, 2010.

  1. Fisherking

    Fisherking New Member

    426
    0
    0
    I was wondering what it takes to free float a 10/22 barrel do you use a difrent V block. How do they do it for the bull barrels.
    Thanks F.K.
     
  2. jeepcreep927

    jeepcreep927 New Member

    1,105
    0
    0
    Ruger 10/22 Bedding Experimentation

    This is *sort of* how I did mine, however I pinned the receiver to the stock at the rear trigger group per instructions available on rimfirecentral.com.

    The receiver is is absolutely rock solid in the stock this way. There are few other, more complicated ways like adding a partial barrel sleeve, but I wanted something that didn't require machining parts. Only thing about pinning the receiver is that you have to drill out the hole or holes, depending if you use both to pin through, in the receiver and trigger group.

    Good luck.
     

  3. jeepcreep927

    jeepcreep927 New Member

    1,105
    0
    0