DS Arms ZM 4 lower build

Discussion in 'AR-15 Discussion' started by loctite44144, Jun 3, 2013.

  1. loctite44144

    loctite44144 New Member

    232
    0
    0
    What up all. I am staring my first AR build. Just got a DSA ZM 4 complete lower with a magpul miad postal grip and a B A D lever. I would like to build it as a 223/556 any suggestions on an upper , BCG and so on and so on
     

    Attached Files:

  2. Garadex

    Garadex New Member

    1,267
    0
    0
    You have a green magazine in your black rifle. Does that clash? I've never been good at matching colors. :D
     

  3. loctite44144

    loctite44144 New Member

    232
    0
    0
    I know I know it was a free mag. I have been using it as a vise block
     
  4. AgentTikki

    AgentTikki New Member

    3,496
    0
    0
    Phase 5 > Troy > Magpul bad lever.

    Get the Troy, same price as the Magpul but nicer. Phase 5 is pricey and its a @#$@$#% pain in the @ss taking that roll pin out for your bolt release.

    What's a Magpul MIAD postal grip? Does it make you go postal? ;)

    Honestly I have the miad, and got rid of it. The MOE+ rubberized is so much more comfortable not to mention grippy. I have them on ALL my builds.
     
  5. BigBizz87

    BigBizz87 New Member

    451
    0
    0
    Just curious but why is the troy better then the Magpul what r the differences I havent used either myself but intrigued by them
     
  6. AgentTikki

    AgentTikki New Member

    3,496
    0
    0
    The Troy is a bit better because the contacts points (where my fat fingers actuate the lever) are a little bigger and the texturing is a bit more aggressive. I swear its a bit lighter too, but I'm not about take mine off to measure the weight over a quarter oz. Either works, but if I were to buy another, I'd go Troy or EBRv2.
     
  7. BigBizz87

    BigBizz87 New Member

    451
    0
    0
    Thanks for the info I appreciate it as always!