Firearms Talk banner
1 - 1 of 1 Posts

·
Banned
Joined
·
6,489 Posts
I would slug the bore. The bore is most likely under sized or has a tight spot. This causes a higher pressure when cold throwing high. A very small amount of linal expansion allows the barrel to correct. I would try pushing a tight patch down the barrel feeling for a tight spot. The other problem could be set in the barrel from correction bending at the factory. I would return to the maker.:)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top