CMP Notice on M1 Carbine Problem

Discussion in 'Curio & Relic Discussion' started by Uncle Russ, Mar 15, 2008.

  1. Uncle Russ

    Uncle Russ New Member

    Received the below email from the CMP folks regarding an M1 Carbine I recently purchased. If you've recently purchased a CMP Carbine (either from them or a 3rd party), you may want to inspect the barrel for this hole. I'll be looking at mine later today.

    Earlier today CMP armorers performing Inspection & Repair operations on a recently received small quantity of M1 carbines found several that had a hole (1/4” in diameter) drilled on the bottom side of the barrel, approximately one inch from where the barrel screws into the receiver.

    Although our inspections will prevent carbines with these barrels from being sold and shipped, as an extra safety precaution, we are notifying (by email and telephone) all of our customers who may have received a carbine from this latest batch and advising them to inspect the underside of the barrel or to have a qualified gunsmith make the inspection. Please see the attached photo. [​IMG]

    Only a limited number of carbines shipped between March 3, 2008 and March 13, 2008 are affected by this notice.

    Shooting a Carbine in that condition is dangerous and may cause injury or death to the shooter. DO NOT SHOOT YOUR M-1 CARBINE!

    If your Carbine has a hole in the underside of the barrel (as shown in the attached photo) please contact [email protected], 256-835-8455 x 1141, at CMP for further instructions.

    If you no longer have possession of the Carbine, please furnish a copy of this letter to the person who currently possesses the Carbine and provide us with his or her name and address.

    We thank you for your support.

    Orest Michaels
    Chief Operating Officer
  2. ScottG

    ScottG Active Member

    Fortunately I got mine before that. But again, thanks to the CMP for getting the notice out quick.