Chamfer 45acp cylinder

Discussion in 'Gunsmithing Forum' started by thundershot, Dec 3, 2011.

  1. thundershot

    thundershot New Member

    8
    0
    0
    Have S&W625 thinking about chamfering the cylinder myself. Does not seem too difficult. Any input would be great.
     
  2. hiwall

    hiwall Well-Known Member

    4,282
    52
    48
    As long as very little metal is removed it should not be a problem.
     

  3. trip286

    trip286 New Member

    18,658
    1
    0
    Be very, very careful. I don't think any of us have to tell you that if you screw it up your gonna have to replace the cylinder. I'm not sure but I think a new cylinder costs more than paying someone to chamfer it for you.

    Do the job very slowly and in very small increments.