Bushmaster M17s "double-tap" PROBLEMS!

2322 Views 4 Replies 4 Participants Last post by OldGnome, 3 mo ago

Hesher420

Discussion Starter · Sep 21, 2011

Has anyone any experience with this problem? Occasionally, the weapon will fire 2 or 3 rounds downrange with a single trigger pull. It happens very randomly. Throughout a 20 round mag, 7-10 shots will be singles and the rest will be multiples.

***page 15 here has an explosion drawing

I have disassembled and inspected the lower end and cannot find any worn or broken parts. Once the sear(30-417) releases the hammer(30-413), the disconnector(30-418) is in the correct position to catch the hammer upon its return to the cocked position. The disconnector spring(30-419) is in place and is intact. The entire "ignition" assembly is free of carbon, and operates smoothly without any hung-ups. When the lower is separated from the upper for inspection, and the trigger is worked and the hammer returned manually everything seems to be operating correctly.

Does anyone have any ideas why this could be happening?

If I have to, I'll take it to a gunsmith to have it checked out, but I don't believe many in my area are familiar with this gun.

Bushmaster's repair dept. was NO help! They basically said, We don't make it anymore, We don't carry parts for it anymore, You're on your own.

Save

1 - 1 of 5 Posts

Sniper03

· #2 · Sep 21, 2011

Replace the disconnector spring first. Has nothing to do with in the correct position in this case. Normally it is that which causes the problem since the spring is weak! This allows the Disconnector to bounce and release the hammer too early, while the shooter still has the finger on the trigger held to the rear. If that does not work also replace the disconnector. If that doesn't work I would replace the trigger assembly first. I have seen some lately that were formed incorrectly. As I state in my classes just because parts are new do not assume they are correct.

03

Save

1 - 1 of 5 Posts

Top Contributors this Month