Buff It Out?

Discussion in 'General Handgun Discussion' started by knockout, Jun 14, 2007.

  1. knockout

    knockout New Member

    5
    0
    0
    I scratched the bottom of the barrel of my 5.5" stainless gloss steel Ruger Old Army Revolver. I don't know how, I think it was when I took the base pin off when the barrel was still hot, I think it was much softer then? Is there a way to buff this out? Should I send it back to ruger to do this? Will they? Or can any gunsmith take care of this?
     
  2. Gearguy10

    Gearguy10 New Member

    51
    0
    0
    Depends on how deep the scratch is, but as long as the barrell isn't plated it should be able to be buffed out. Ask around for a good gunsmith. It is amazing what they can do.
     

  3. deerhuntguy

    deerhuntguy New Member

    50
    0
    0
    try some "Neverdull"