beretta 84fs

Discussion in 'Engraving & Refinishing' started by jj380acp, May 7, 2010.

  1. jj380acp

    jj380acp New Member

    5
    0
    0
    hi everyone out there i just got my first Beretta. it was past on to me but with a lot of damage to the slide and the trigger guard. the slide has a lot of rust which has made holes in the metal and the trigger guard has been rough up so some of the metal has eaten away. can i get some advice on how to repair the 2 problems and to get a finish as close to the original Burniton finish. thanks very much
     
  2. danf_fl

    danf_fl Retired Supporter

    12,369
    57
    48
    Wasn't this in the gunsmithing section? Have you considered purchasing another slide? On the trigger guard, look at using JB weld. It can be shaped into the correct form, then painted with dura-coat.
     

  3. NGIB

    NGIB New Member

    7,143
    1
    0