Barrel Drilling Question

Discussion in '.22 Rifle/Rimfire Discussion' started by Vipersnipe, Dec 20, 2010.

  1. Vipersnipe

    Vipersnipe New Member

    6
    0
    0
    I have a question for you gunsmiths out there. I was wondering how much it would cost to drill a hole that would normally fit a front sight on my Remington 597. I have the model that came with the scope, so I do not have the hole where the front sight would be. I need this hole so I can attach my barrel part of my archangel stock. I was just wondering how much it would cost to tap my barrel.
     
  2. Vipersnipe

    Vipersnipe New Member

    6
    0
    0
    [​IMG] It would be the part that the bayonet is attached to
     

  3. masterPsmith

    masterPsmith New Member

    1,346
    2
    0
    Anywhere from $15 to $30 a hole, or more, depending on the gunsmith and area you are in.

    Jim........