Firearms Talk banner
1 - 3 of 3 Posts

· Registered
Joined
·
1,730 Posts
BCM was out of stock when I ordered my M4 stock, or else I would've gotten one there. Theres a ton of reviews on Midwayusa and cheaperthandirt from owners that claim thier new wrench either won't work, doesnt fit, broke, stripped, and/or bent. I am simply asking you guys who have the knowledge from actually owning these firearms, what tool/s you have that work well. My local gun shop has a DPMS tool that I was going to buy and try but I dont want to buy it, have it be a POS and then make a hassle with the retailer trying to return it, if I could have prevented it by asking first.
Mine from Brownells works fine.
 

· Registered
Joined
·
1,730 Posts
As far as the AR wrench, some like mine have a slot for a 1/2" drive tool. I like being able to put a torque wrench on the barrel nut.
 

· Registered
Joined
·
1,730 Posts
I beleive the Technical Manual says tighten the buffer tube to about 30 ft lbs, but I know a lot of mfrs. go much tighter.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top